Free DFM Analysis & Free Quote
& On-demand Manufacturing
Try a contact & see what we can help !
It’s another aerospace lighting tray. The size is a little bit smaller than the medium one. About 150mm*30mm*30mm. A 2-cavity injection mold for medium volume production. It’s from the same project, which was a general injection molding job, including about 10 toolings in total.
It’s a 3-plate injection mold, with pin-gate for balance injection molding, so that to eliminate the deformation. Part material is also fire retardant PC+ABS, which is specified by our customer. Lighting textures for cosmetic external surfaces. There are 4 manual inserts in the injection tooling, which is for forming the clips and de-molding.
Again in each injection molding cycle, we can see the mold open, our workers taking off the sprue, taking the part out off the mold, putting the manual inserts back, closed the safety door, the mold closed, then material injection for the next shot. It’s a common injection molding cycle. Just with the manual insert, it would be not efficiency enough, but very good for low-volume production and startups.
Danke Mold is a professional plastic injection molding manufacturer. If any injection molding inquiries, just email us via info@dankemold.com.
Danke Mold Address
Zhongshan Factory :
No. 8 Zhanxing Road, Dahuan Village,
The Torch Development Zone,
Zhongshan City, Guangdong Province
China 528437
Hongkong Office (for quotes and invoices) :
Flat/RM A1 11/F, Winner Building, 36 Man Yue Street, Hung Hom, Kowloon, Hong Kong SAR
Contact Us
Tel: (+86) 181-2536-1623
Tel : (+86) 0760-8828-9620
E-mail : info@dankemold.com
Free DFM Analysis & Free Quote
& On-demand Manufacturing
Try a contact & see what we can help !
181-2536-1623